12mm Round Punch

All sizes listed are in stock. Contact us for custom sizes not listed. Commonly paired with 35mm Round Dies.
*12mm offset punches are designed for punching angle iron leg down on Geka™ ironworkers. Maximum material thickness 1/4". Special punch holder required.

Additional Information

Dimensions: Shank Diameter: 0.472" Overall Length: 1.968"
Punch & Die Clearance: Use chart above to determine recommended die clearance. The punch and die should NOT be the same size.
Note: Material thickness should not exceed punch size. Not recommended for material thicker than 1/4".
Cross Reference:

12mm Punch
AP-3653, CST-12MM

Proudly Made in the USA