35mm Round Die

All sizes listed are in stock. Contact us for custom sizes not listed. Commonly paired with 12mm Round Punches.
*35mm offset dies are designed for punching angle iron leg down on Geka™ ironworkers. Maximum material thickness 1/4". Special die holder required.

Additional Information

Dimensions: Outside Diameter: 1.377" Height: 0.687"
Punch & Die Clearance:Use chart above to determine recommended die clearance. The punch and die should NOT be the same size.
Note: Not recommended for material thicker than 1/4".
Cross Reference:

35mm Die
AP-3656, CST-35MM

Proudly Made in the USA